Hi
First time I've submitted to this group and unfortunately it has to be
to ask some kind soul for some help.
For the last 5 years I have been sup****ting a 10-year old PIC 16C57
program by 'tinkering' - i.e by editing the assembler, using MPLAB
and sending the HEX file to the factory for them to test it in the
product hardware. This has been adequate for the low impact
modifications that have been required.
However, I now have to do a serious modification to this program which
will require *me* to do thorough testing.
I have retrieved my MPSTART-16C chip programmer from its box (where
it's been for the last 5 years) set it up and connected it to COM1 on
a WIn98 PC using the 9-pin 'D' connector straight through lead
supplied with the kit.
Although MPSTART appears to successfully connect to the programmer
without any 'squeeks', it will only ever read back all zeroes from any
chip, blank or otherwise. The LED on the programmer *does* light up
while comms are apparently occurring.
The PICSTART manual does not specify the serial baud rate, number of
data bits or parity (but does mention the use of hardware flow
control).
I am hoping that the symptoms are not caused by a dead programmer but
that I simply have the wrong comms configuration.
The last time the programmer was used, it was connected to a real
*DOS* PC but unfortunately I can find no notes about how I got it
working first time round.
So . . please can anybody confirm what the comms configuration should
be?
TIA
pOTRice
