"Adam Ierymenko" <adam.ierymenko@[EMAIL PROTECTED]
> wrote in message
news:7f53d811-7dfc-404c-b6b6-996e21124e14@[EMAIL PROTECTED]
> Hey guys...
>
> I'm looking for a deep technical answer on this question from someone
> who knows something about chip design or at least chip quality
> control, technical specs, etc.
>
> I'm curious about whether undervolting can actually damage a chip. I
> know it could make it unstable, but could it actually damage the chip
> or shorten its life span (or the life span of other components)? Is
> this something to be concerned about or is it something like "yeah, it
> might shorten the theoretical life span from 100 years to 50 years"?
>
> The reason I'm asking is this comment:
>
> "Depending on the voltage your adjusting you could fry the chip by
> under-volting. Most chips these days require a few different voltages
> to run, and if you lower one, there are sometimes sneak paths where
> the logic that is not getting enough power can draw power from the I/O
> voltage, or other auxiliary voltages on the chip which can burn out IO
> and other parts since they were never designed to carry the amount of
> current drawn through the sneak path. There are usually some
> protections in place to prevent the burn out, but with millions of
> transistors on a chip it's sometimes hard to catch all of the possible
> sneak paths."
>
> Here's the context of the comment:
>
> http://forums.macrumors.com/showthread.php?p=5213018
>
> Is this really a potential issue that one would face in the normal
> life span of a computer? I would think that undervolting (keep in mind
> no overclocking here) would be much safer than overvolting/
> overclocking where I have heard fry stories. :)
Hi,
There are 2 things that could go wrong:
1) What you're describing: when multiple voltage come into play and start
to
leak, you can expect side effects like latch up or a higher voltage going
to
a low-voltage region of the chip and frying your transistors which have
only
a few atoms of isolation (typically, the IO is made with thicker oxide
FETs
to run higher voltages than your core in order to pump the nescessary
energy
fast enough to the peripheral chips).
2) If you have too much current flowing from one part of the chip to
another. Even if it comes from the same supply, the current drawn would be
too much to handle (imagine powering you CPU with 1 pair of pins instead
of
the 100s they use). In this case, your electrical connection melts away
like
a fuse.
Regards,
Alvin.
|
