Re: F-plug need to be fully tightened?

"Michael A. Terrell" <mike.terrell@[EMAIL PROTECTED]
> wrote in message
news:D****nbwwk_cJcE3VnZ2dnUVZ_uednZ2d@[EMAIL PROTECTED]
>
> Peto wrote:
> >
> > On Wed 17 Sep08 05:04, Michael A. Terrell wrote in
> > <news:OLOdnXQKjK5CHE3VnZ2dnUVZ_umdnZ2d@[EMAIL PROTECTED]
>:
> > >
> > > Tim Perry wrote:
> > >>
> > >> Please post a link to your recomended product.
> > >>
> > >
> > > <http://www.gcelectronics.com/order/SubCatPDF/lubricants%2048-49.
> > > pdf>  Part No. 10-2610 Tunerlub is what I've used since the '60s.
> > >
> >
> > I'm the OP. Do you smear Tunerlube on the threads or do you dunk the
> > plug into it (so the threads and centre connector are both covered in
> > Tunerlube?)
>
>
>    A very thin film, applied with a Q-tip is all that is needed.
>

Michael, I'll see you tunerlube and raise you a Molykoat (s)
http://www.dowcorning.com/content/news/iam_news25.asp

However in this application any oil, grease, or any other gunk will
attract
dust on both the  jack and the plug when they are apart. the resultant
sludge will necessitate cleaning both ends (then we can argue about the
best
cleaning solution)

I am not on a mission or crusade or anything. I use cleaners, sealers,
etc.
as needed and have for years. My favorite is Caig de-oxit.

Even outdoors for most instillations I find little use for chemicals on F
connectors. Usually tape and a Skotchcoat are sufficient for many years of
faithful service.

Large connectors the story is a bit different.  The O-rings on conduit 
and
coax transmission line should be coated with the silicon paste, usually
supplied with new parts or replacement kits.

In any even I think we have beaten the subject to death.

My recommendation to the Op is get a 4" (100 mm) crescent wrench and place
it on your key ring. It will then be handy for all occasions. Snug the
connector down
and enjoy your high speed access.