I recently purchased an oscilloscope on Ebay. It is a 100Mhz model. I
was configuring the scope using the calibration output, which is a
1Khz 2 volt square wave. The horizontal line drawing on the scope
looks good, however, the vertical trace ****tion on this wave is barely
visible at the highest brightness setting. Is the normal, or is there
a problem with the scope? Is this common with analog scopes? This is
my first oscilloscope, so I=92m not sure. Here=92s a photo I took. Any
ideas?
http://www.flickr.com/photos/27262651@[EMAIL
PROTECTED]
