by "JMini" <j.minihane@[EMAIL PROTECTED]
>
Jun 24, 2008 at 05:34 PM
On 6/22/2008 2:52:30 PM, instantwow wrote:
> I recently purchased an oscilloscope on Ebay. It is a 100Mhz model. I
> was configuring the scope using the calibration output, which is a
> 1Khz 2 volt square wave. The horizontal line drawing on the scope
> looks good, however, the vertical trace ****tion on this wave is barely
> visible at the highest brightness setting. Is the normal, or is there
> a problem with the scope? Is this common with analog scopes? This is
> my first oscilloscope, so I’m not sure. Here’s a photo I took. Any
> ideas?
>
> http://www.flickr.com/photos/27262651@[EMAIL
PROTECTED]
> Thanks.
>
It's just making the transition from 0V to 2V almost instantaneously (high
slew rate). Leaving little time for the phosphor on the screen to respond.
It
looks like it's responding well.
